Why does my Bosch Washer smell?
Odors can form in your Bosch washer due to humidity and detergent residue, which may promote bacteria growth. To prevent this, when you are not using the appliance, leave the door and detergent drawer open to allow residual water to evaporate.
What should I do if my Bosch WGB256A1GB is leaking at the water inlet hose?
If water is leaking at the water inlet hose of your Bosch washer, check the installation of the hose to ensure it is correctly connected. If the hose is damaged, contact customer service.
What should I do if my Bosch Washer is leaking at the water outlet hose?
If water is leaking at the water outlet hose of your Bosch washer, check the installation of the water outlet hose to ensure it is correctly connected. If the hose is damaged, replace it.
What to do if my Bosch Washer shows error E:30 / -10 or the tap is turned off?
If your Bosch washer displays error code E:30 / -10, or indicates that the tap is turned off, you should first turn on the tap. Then check the water inlet hose for any kinks or obstructions. Also, inspect and clean the filter in the water inflow, ensuring it's free from blockages. Verify that the tap provides sufficient water pressure. If the problem persists, it could be a defective water level measuring system, in this case it is recommended to wait approximately 5 minutes until the draining process ends, restart the appliance, and if required, start the draining process again. If the fault still persists, you should contact customer service.
What to do if my Bosch WGB256A1GB displays error E:30 / -80 or detergent solution is not being pumped out?
If your Bosch washer shows error "E:30 / -80" or indicates that the detergent solution is not being pumped out, check the installation of the water outlet hose to ensure it is not connected too high, kinked, trapped, or impermissibly extended. Clean the drain pipe and the water outlet hose to remove any blockages. Verify that the drain pump is not blocked and that the pump cover is correctly installed. If you are using intelligent dosing, reduce the basic setting. If you are dosing manually, reduce the amount of detergent for the next washing cycle with the same load.
What does it mean if my Bosch WGB256A1GB displays error E:30/-20?
If your Bosch washer displays error code E:30/-20, this indicates a critical malfunction. Turn off the water tap. Wait approximately 5 minutes until the draining process ends. Restart the appliance, and if required, start the draining process again. If the fault persists, contact customer service. This error may also appear if the detergent dosage is too high, so reduce the amount of detergent for the next washing cycle with the same load if you dose manually. Avoid adding any extra water to the appliance while it is operating. Ensure that the detergent drawer has been pushed in fully and that the pump unit is inserted correctly.
Why is my laundry too wet after spinning in my Bosch Washer?
If your laundry is too wet after the spinning cycle in your Bosch washer, it could be due to a low spin speed being selected. Try starting the Spin programme. Alternatively, the appliance might be using a reduced spin speed to address an imbalance. In this case, redistribute the laundry in the drum and then start the Spin programme.
What does error H:32 mean on my Bosch WGB256A1GB?
If your Bosch washer displays the error code H:32, it means that the appliance has interrupted the spin cycle because the laundry is unevenly distributed. To resolve this, redistribute the laundry in the drum.
What to do if my Bosch WGB256A1GB shows error E:38 / -25 / -26?
If your Bosch washer displays error code "E:38 / -25 / -26", and the fault persists, clean the drain pump. Also, clean the inlet opening in the rubber gasket.
What does error E:10 / -00 / -10 / -20 mean on my Bosch Washer?
If your Bosch washer displays the error code E:10 / -00 / -10 / -20, it indicates that the pump for the intelligent dosing system is blocked. If the fault persists, contact customer service.
General| Appliance placement | Freestanding |
|---|---|
| Loading type | Front-load |
| Product colour | White |
| Built-in display | Yes |
| Control type | Electronic |
| Door hinge | Left |
| Drum material | Stainless steel |
| Inverter technology | Yes |
| Maximum spin speed | 1200 RPM |
| Spin Speed | 1200 RPM |
| Spin-drying class | B |
| Washing class | A |
| Delayed start timer | Yes |
| Delayed start | Yes |
| Remaining time indication | Yes |
| Child lock | Yes |
| Energy efficiency class | A+++ |
| Water consumption per cycle | 48 L |
| Water Consumption | 48 L |
| Dimensions (H x W x D) | 850 x 600 x 550 mm |
| Weight | 70 kg |
| Delay Start | Yes |
| Type | Washing Machine |
| Noise Level (Spinning) | 76 dB |
| Width | 60 cm |
| Height | 85 cm |
To Next Page
