Switching the push-assistance function on/off
The walk assistance makes it easier to push your eBike. The speed in this function depends on the selected gear and can reach a maximum of 4 km/h.
The push assistance function must only be used when pushing the eBike. There is a risk of injury if the wheels of the eBike are not in contact with the
ground while using the push assistance.
To start walk assistance, press the (6) button for more than 1 s and keep it pressed. The battery charge indicator (13) goes out and a white moving
light in the direction of travel shows that it is ready.
To activate walk assistance, one of the following actions must occur within the next 10 s:
– Push the eBike forwards.
– Push the eBike backwards.
– Perform a sideways tilting movement with the eBike.
After activation, the motor begins to push and the continuously lling white bars change colour to ice-blue. If you release the (6) button, walk
assistance is stopped. You can reactivate walk assistance within 10 s by pressing the (6) button. If you do not reactivate walk assistance within 10 s,
walk assistance automatically switches off.
Walk assistance is always ended if:
– the rear wheel jams,
– the bicycle cannot move over ridges,
– a body part is blocking the bike crank,
– an obstacle continues to turn the crank,
– you start pedalling,
– the (4) button or on/off button (12) is pressed.
Walk assistance has a roll-away lock, i.e. even after walk assistance has been used, rolling backwards is actively curbed by the drive system for a few
seconds, and you cannot push the eBike backwards or can only do so with difculty. The push assistance function is subject to local regulations; the
way it works may therefore differ from the description above, or the function may even be deactivated completely
ASSIST MODES & PUSH ASSIST
MINI REMOTE (BRC3100 | BCR3300)
23
To Next Page
Loading...
