Positioning and connecting en
17
3. Undo and remove the screws on the
horizontal transport strut.
4. Remove the transport strut.
Hose and cable lengths
Connection on left side
or
Connection on right side
Note: If the supply hose is too short for
your connection, you can order an
extension from the after-sales service.
Water inlet
:Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Do not immerse the Aqua-Stop safety
valve* in water (it contains an electric
valve).
* Depending on the model
Observe the following when connecting
the appliance:
Notes
■ Only operate the appliance using
cold mains water.
■ Do not connect the appliance to the
mixer tap of an unpressurised hot-
water boiler.
■ Do not use a used supply hose. Only
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
( ~ 135 cm
0 ~ 90 cm
8 ~ 90 cm
@ 0 cm ~ 100 cm
7
#
( ~ 95 cm
0 ~ 130 cm
8 ~ 135 cm
@ 0 cm ~ 100 cm
#
To Next Page
Loading...
