en Operating the appliance
36
ã Pre-treatment
Touch ã Pre-treatment to activate
W (Handsoaking) or T (Prewash).
W (Handsoaking): Before the main
wash cycle starts, the washing remains
for longer in the water to partially
dissolve intensive soiling. After the
handsoaking process (approx. 70
minutes), it is possible to add laundry
within separate 15 minutes while '
blinks, touch Start/Reload A button to
continue the programme after you add
laundry. Afterwards the main wash cycle
starts. And if you don’t need to add
laundry, you can touch Start/Reload A
button to continue the programme
immediately, don’t need to wait 15
minutes.
Notes
■ Put the detergent into dispenser I
and II.
■ To avoid discolouration, only soak
laundry of the same colour together.
T (Prewash): Prewash for heavily
soiled laundry.
Note: Put the detergent into dispenser I
and II.
Ï Rinse Plus
Additional rinse cycle depending on the
programme; longer programme length
for particularly sensitive skin and/or for
areas with very soft water.
G SpeedPerfect
Washing in a shorter time while
achieving a washing result that is
consistent with the normal performance.
Touch G SpeedPerfect to activate or
deactivate this additional programme
setting.
Note: With the G SpeedPerfect
additional programme setting activated,
the maximum load of washing will be
reduced, and extra water will be needed
for the washing process.
1 Operating the
appliance
Operati ng the appliance
Preparing the appliance
The appliance was tested before
delivery. To remove residual water from
the test procedure, the first wash cycle
should be run without laundry using the
Cottons i 90°C programme.
~ "Before washing for the first time"
on page 21
Notes
■ Never switch on a damaged
appliance!
■ Inform customer service!
1. Insert mains plug.
:Warning
Risk of death from electric shock!
Risk of death if live parts are
touched.
– Never pull out the mains plug by
tugging the power cord.
– Insert/pull out the mains plug
with dry hands only.
2. Turn the water tap on.
To Next Page
Loading...
