Bosch WNA254U1AU - Appliance Settings

en Appliance settings
40
Notes
■ Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■ Wipe the rubber seal dry.
■ Leave the door and detergent
drawer open so that any residual
water can evaporate.
■ Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
Q Appliance settings
Appliance setti ngs You can change the following settings:
■ The volume of the end signal.
■ The volume of the button signal.
■ Switching the drum care information
signal on/off.
You will need to activate the setting
mode in order to change these settings.
Activate setting mode:
1. Set the programme selector to
position 1. The appliance is switched
on.
2. Touch and hold the 0 Spin Speed
button and, at the same time, turn
the programme selector clockwise to
position 2. Release the 0 Spin
Speed button.
The setting mode is activated and the
preset setting appears in the display
panel.
Changing the volume and drum care
information
Use the ñ Finished in button to change
the following settings at the
corresponding programme selector
positions:
■ 2: The volume of the end signal.
■ 3: The volume of the button signals.
■ 4: Switching the drum care
information signal on/off.
Exiting setting mode
You can now end the process and set
the programme selector to the Off
position. The settings are saved.
1/2/3/4... positions on the
programme selector
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
Ž on
Πoff