Bosch WUU28T21 - Remove Transport Locks

enSet up and connect
WARNING
Risk of injury!
When operating on a base, the device
can tip over.
▶ Before using the device for the first
time on a base, be sure to fasten it
with the retaining tabs → page 28 of
the manufacturer.
location
kitchenette
requirements
The device only
under
hender working
put up a plate
which are fixed to
the neighboring
connected
is. Required
niche width:
60 cm.
ATTENTION!
Freezing residual water in the
device can damage the device.
▶ Do not set up and operate the device
in areas where there is a risk of frost
or outdoors.
If the device is tilted more than 40°,
residual water in the device may leak
and cause property damage.
▶ Tilt the device carefully.
▶ Transport the device in an upright position.
A notice:if
the cover plate
Will get removed,
must the
sheet metal cover plate
te
→ "Accesories",
page 28 before
the installation
be strengthened.
location
base
requirements
On a wall No hoses
between wall
and device
jam.
The device with
retaining tabs
→ page 28 be
consolidate.
4.4 Remove transport locks
wooden beam ceiling The device on a
water-
standing wooden
plate (strength
at least 30 mm)
put up that
firmly to the floor
is screwing.
The device is secured for transport
with transport locks on the back of
the device.
A notice:Keep the screws of the
transport locks and the sleeves for
later transport → page 47 on.
14