enservice
13.10 Soaking laundry 13.13 Continue program at
rinse stop
A notice:No additional detergent is
necessary. The suds are then used
for washing.
requirements
¡The rinse hold is activated.
→
"Buttons", page 23
¡The last rinse of the set
th program is finished and the
laundry is in the rinse water.
1.Start the program.
2.To pause the program, open after
about 10 minutesStart/ Reloadto
press.
1.The programSlingor set a program
for draining.
→
"programs", page 24
3.To continue the program, after the
desired soaking timeStart/Reloadto
press.
2.onStart/Reloadto press.
13.11 Add laundry
13.14 Remove laundry
1.onStart/Reloadto press. The
device pauses.
1.Open the appliance door.
2.Remove the laundry.
A notice:if
It is not possible to add laundry.
appears is
When goes out, it is possible to add
laundry.
13.15 Switch off the device
1.Open the program selectorOut of
place.
2.Open the appliance door.
3.Add or remove the laundry.
2.Turn off the tap.
3.Wipe the rubber boot dry and
remove foreign objects.
4.Close the appliance door.
5.onStart/Reloadto press.
13.12 Cancel program
1.onStart/Reload
2.Open the appliance door.
to press.
When the temperature and water
level are high, the door will remain
locked for safety reasons.
– If the temperature is high, start
the programWash .
– If the water level is high, start the
programSling or select a suitable
pumping program.
→
"programs", page 24
4.Leave the appliance door and the
detergent drawer open so that any
residual water can dry off.
3.Take out the laundry
→
page 32
.
men
32
To Next Page
Loading...
