enSet up and connect
Connect drinking water
contamination by backflow (according
to DIN EN 1717). The connection
valves/water taps provided for this
purpose are equipped with this safety
device if the house is properly
installed.
ATTENTION!
When pumping out, the water drain
hose is under pressure and can detach
from the installed connection point.
▶ Secure the water drain hose
against unintentional loosening.
1.Connect the water inlet hose to the
device.
A notice:Note the pump heights.
The maximum pumping height is 1
The connection
place with one
hose clamp
(24-40 mm)
chern.
bathroom sink the water
running hose with
a manifold
→
page 28
fix and
secure.
2.Connect the water inlet hose to the
tap (26.4 mm = 3/4").
plastic pipe
with rubber sleeve
or gully
the water
running hose with
a manifold
→
page 28
fix and
secure.
3.Open the tap carefully and check
whether the connection points are
tight.
Connection types water drainage
The information will help you to
connect this device to the water drain
shut down.
16
To Next Page
Loading...
