encleaning and care
Clean drain pump
4.Install the pump cover.
Precondition:The drain pump is
empty. →
page 34
‒ Ensure that the pump cover
components are assembled
correctly.
1.Since there may still be residual
water in the drain pump, carefully
unscrew the pump cover.
‒ Coarse contamination can cause
the filter insert to get stuck in
the pump housing. Loosen dirt
and remove filter insert.
5.Screw the pump cover on as far as
it will go.
90°
2.Clean the interior, the threads of the
pump cover and the pump housing.
The handle of the pump cover
must be vertical.
Before the next wash
Run the program to prevent unused
detergent from flowing down the
drain the next time you wash
pumpingthrough after you have
drained the drain pump.
1.Open the faucet.
The pump cover consists of two
components that can be
disassembled for cleaning.
2.Plug in the power cord.
3.Turn on the device.
3.Making sure
wheel of the lye pump
leaves.
the wing
turn mpe
4.Fill one liter of water into chamber
II.
36
To Next Page
Loading...
