Troubleshootingen
Disturbance Cause and troubleshooting
Repeated
fling.
Imbalance control system compensates for imbalance by
distributing the laundry several times.
▶ No error - no action necessary.
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Change program duration
changes during the
washing process.
Program flow is electronically optimized. This can lead
to a change in the program duration.
▶ No error - no action necessary.
Imbalance control system compensates for imbalance by
distributing the laundry several times.
▶ No error - no action necessary.
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Foam control system switches on a rinse cycle if the
foam builds up too much.
▶ No error - no action necessary.
Water is not visible
in the drum
bar.
Water is below the visible range.
▶ No error - no action necessary.
▶ Do not add additional water to the device during
operation.
Drum jerks
program start.
The cause is an internal engine test.
▶ No error - no action necessary.
In the chamber
there is residual
ser.
be Insert in chamber is clogged.
▶
→
"Cleaning the detergent drawer", page 33
vibration and movement
the appliance during
spinning.
Device is not aligned correctly.
▶
→
"Align device", page 17
Device feet are not fixed.
▶ Fix the device feet.
→
"Align device", page 17
Transport locks are not removed.
▶
→
"Remove transport locks", page 14
.
drum turns,
Water doesn't run in.
Load detection is active.
▶ No error, no action necessary.
A notice:The load detection can take up to 2 minutes.
43
To Next Page
Loading...
