16
English
1.6.3 Message event
A Message event (only in combination with the ControlSpace
™
AMS-8 Message Card) can be used to
route a digital message to a single or group of rooms at a certain time and day. In below modules one
can change the Start and End time (only if Repeat setting is not ‘once’) of the event, select the day(s) of
the event, select the message number (1 up to 8) from the CSAMS-8 Message Card and select the rooms
the message needs to be routed to. It is also possible to repeat the activation of this event by using the
‘Repeat’ button, selecting 15, 30 or 60 minutes as repetition time.
Press the following buttons to:
(days) show and select the days (from the info field) required for this event
(message) select a pre-recorded message (1...40) from the message storage card
(repeat) set the repetition interval for the scheduled message within this event
change the start and end time for this event
move a selected room from ‘available outputs’ to ‘selected outputs’
move a selected room from ‘selected outputs’ back to ‘available rooms’
1. ControlSpace
™
AMS-8 LIVE Installer Software
To Next Page
Loading...
