Changing Your System Setup
UNIFY®
system overview
The UNIFY intelligent integration system guides you through the initial process
of
setting up and configuring your system. It helps you choose the right cables and
inputs, and program the
LIFESTYLE®
remote to operate your connected devices.
After completing the initial setup, you can use the UNIFY system at any time
to
change your system setup and configuration.
Using
the
UNIFY
menu
To
display the UNIFY menu on your
TV,
press the Setup button on the front
of
the
control console. Using the navigation buttons on the remote, select the function
you want and follow the instructions on the screen.
Resume initial
setup
If your initial setup is incomplete, you can return
to
the UNIFY setup
process at the last completed event.
Restart initial setup If your initial setup is incomplete, you can start the UNIFY setup
process from the beginning.
Reconnect
Acoustimass®
(135 series
II
systems only)
Language
ADAPTiQ®
TV setup
Source setup
Add a new device
Update
Teach mode
Exit UNIFY
26-
English
Follow the onscreen instructions
to
reconnect the speaker array with
the Acoustimass module.
Change the language
of
the onscreen display.
Start the ADAPTiQ audio calibration process. After ADAPTiQ has been
run, this menu item allows you
to
disable or enable ADAPTiQ.
After your
TV
is connected
to
the console, you can:
• Program the
LIFESTYLE®
remote
to
control your TV
• Manually enter remote control
IR
device codes
• Replace your
TV
• Add, change, or remove the TV audio connection
For sources connected to Input 1-5
of
the control console, you can:
• Change the name
of
the device
• Program your remote to control the device and add
theIR
emitter
• Manually enter remote control
IR
device codes
• Remove the device
• Add
or
change the type of audio or video connection
After your initial setup is complete, you can add another device or
accessory to your system.
Used
to
perform a system software update (see "Performing a system
software update" on page 30 for more information).
This item is used
to
send
IR
codes
to
program a learning remote.
Closes the UNIFY menu and returns you
to
the last source selected.
To Next Page
Loading...
