50 - Design Guide
Appendix: How to Set Up IP Address
5. Change IP of PC to 192.168.0.10, Subnet mask 255:255:255.0.
6. Launch CSD. Now MSA12X arrays appear in the Project View.
a. If not, make sure the Project Network Address is 192.168.0.xxx. You can set this by selecting Tools > Set
Project Network Properties.
b. By default, the IP of ESP is 192.168.0.160.
7. You can set up the beam properties of MSA12X without ‘Go Online…” in CSD, as long as the Dante Control
and Endpoint Control are enabled.
8. Make sure to change the input type of each MSA12X device to Analog.
If you do not have a network switch in the system, connect your PC to each MSA12X directly, and repeat the
above process for each array.
Note: You cannot change the beam pattern via a beam preset without a 1U ESP (ESP-880/1240/4120/1600)
with Dante Card, or ControlSpace® EX-1280C in the system.
Switch
MSA12X
MSA12X
PC
Static
IP: 192.168.0.10
Subnet: 255.255.255.0
Static
IP: 192.168.0.101
Subnet: 255.255.255.0
IP: 192.168.0.102
Subnet: 255.255.255.0
Static
To Next Page
Loading...
Need help?
General
