16
Connecting Other Equipment
Français Español English
Using your Wave
®
radio II with other audio equipment
When using a TV, VCR, computer, video game or cassette tape player, you can enhance your
listening experience by playing the audio device through your Wave
®
radio II.
Connecting an audio device to your Wave
®
radio II, requires one of the following cables:
To obtain the correct cable, contact Bose
®
Customer Service or visit a local electronics store.
See the phone numbers listed inside the back cover of this guide.
To connect an audio device, such as your TV, to your Wave
®
radio II:
1. Connect one end of the stereo cable to the output of the audio device.
2. Connect the other end of the cable to the AUX IN connector on the rear panel of your
Wave
®
radio II.
3. Turn on your Wave
®
radio II and the audio device.
4. Press AUX.
5. Press and hold Volume or to adjust the listening level.
Note: If the volume level of your Wave
®
radio II cannot be adjusted high enough, try to increase
the volume level of the connected audio device.
Connecting your Wave
®
radio II to a Lifestyle
®
system
You can use your Wave
®
radio II as a multi-room expansion speaker system for a Bose
®
link-
enabled Lifestyle
®
home entertainment system. Your Wave
®
radio II was set up at the factory
for room B. To change this setting, see “Setting the room code” on page 21.
Contact Bose
®
Customer Service to obtain the required cables and instructions. See the
phone numbers listed inside the back cover of this guide.
• Male-to-male 3.5 mm (
1
/8") stereo cable
• Dual RCA male to
3.5 mm (
1
/8") male
stereo cable
On
Off
Dual RCA male to 3.5mm (
1
/8")
male stereo cable
TV
AUX IN
connector
00.WRII_UKE.book Page 16 Tuesday, July 28, 2009 8:43 AM