Boss DD-5 - Page 10

USING THE MODE LABEL
The DD-5 is supplied with a mode Label which shows the effect obtained with each of the
Mie The Label (which serves as a quick reference) can be attached as shown in the
illustration.
DD-5 MODES
l6
CHANGING
THE
BATTERY
When
the
indicator
goes
dim
or
no
longer
lights
1.
Loosen
the
thumbscrew
at
the
front
of
the
while
an
effect
is
on,
it
means
that
the
battery
is
pedal,
then
lift
the
pedal
upwards
to
open
the
nearly
dead
and
must
be
replaced.
unit.
Replace
the
battery
following
the
steps
below.
i
5
l
*
The
thumbscrew
can
be
left
in
the
pedal
while changing the battery.
— Thumbscrew
humbscrew
—
2.
Remove
the
old
battery
from
the
battery
housing,
and
remove
the
snap
cord
con-
nected
to
it.
/ Pedal
¿Spring Base
3.
Connect
the
snap
cord
to
the
new
battery,
and
7
Coil
Spring
mee:
:
:
place
the
battery
inside
the
battery
housing.
*
Be
sure
to
carefully
observe
the
battery's
polarity
(4
versus
-).
- Guide
Bush
4.
Slipthe
coil
spring
ontothe
spring
base
on
the
back
of
the
pedal,
then
close
the
pedal.
*
Carefully
avoid
getting
thesnap
cord
caught
`
Battery
in
the
coil
spring.
Housing
5.
Finally,
insert
the
thumbscrew
into
the
guide
bush
hole
and
fasten
it
securely.
19