Boss DN-2 Dyna Drive - Operating the Unit

9
Operating the Unit
fig.04
1. After you have made the necessary con-
nections
(p. 7, 8), set the panel knobs as
shown in the illustration.
fig.05
2. Depress the pedal switch to turn the
effect on. (The CHECK indicator lights
when the effect is on.)
3. Adjust the amount of overdrive with the
DRIVE knob.
DRIVE DRIVE
DN-2_e1.fm 9 ページ ２００６年１２月８日 金曜日 午後１時４４分