5
Panel Description
2. CHECK Indicator
This indicator shows whether an effect is
ON/OFF, and also doubles as the Battery
Check indicator. The indicator lights when
an effect is ON.
* If this indicator goes dim or no longer lights
while an effect is ON, the battery is near
exhaustion and should be replaced immedi-
ately. For instructions on how to replace the
battery, please refer to “Changing the Battery
(p. 10).”
* The CHECK indicator is designed for
providing information about effects—such as
their on/off status. It does not indicate
whether the power is on or off.
3. OUTPUT Jack
The OUTPUT jack is used to connect the
unit to an amplifier or another device.
4. INPUT Jack
This jack accepts input signals (coming
from a guitar, some other musical instru-
ment, or another effects unit).
* The INPUT jack also serves as the power
switch. Power is turned on whenever a plug is
inserted into the INPUT jack, and is turned
off when the plug is disconnected. When not
using the unit, you should disconnect any
cord connected to the INPUT jack.
5. Pedal Switch
This switch turns the effects ON/OFF.
6. Thumbscrew
This thumbscrew is loosened to open the
pedal, allowing battery replacement.
* For instructions on how to replace the battery,
please refer to “Changing the Battery (p. 10).”
To Next Page
Loading...
