Boss RC-10R Parameter Guide

19
Connecting a Computer via USB
NOTE
5 Never use your computer to format the “BOSS RC-10R”
drive. Doing so will make the RC-10R inoperable. If
this occurs, you can use the procedure “Restoring the
Factory Settings (Factory Reset)” (Owner’s Manual) to
initialize the RC-10R so that it will operate correctly, but
this will cause all phrase memories to be irrecoverably
lost.
5 Never perform the following actions until you have
disconnected the USB drive. Doing so might make your
computer freeze, or might result in the loss of all of the
RC-10R’s data.
5 Disconnect the USB cable.
5 Allow your computer to enter suspend (standby) or
hibernate mode, restart it, or shut it down.
5 Turn o the RC-10R’s power.
5 Unfortunately, it may be impossible to restore the
contents of data that was stored in the unit’s memory
once it has been lost. Roland Corporation assumes no
liability concerning such loss of data.

Boss RC-10R Specifications

General

Sound effects	Looper, Reverberation
Sound effects quantity	-
DC-in jack	Yes
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired
6.35 mm (1⁄4-inch) input	1
Display type	LCD
Power source type	DC

Weight and Dimensions

Depth	138 mm
Width	101 mm
Height	63 mm
Weight	620 g