Boss RC-10R Parameter Guide

9
MENU
MIDI
Parameter Value Explanation
RX CONTROL CH
OFF, 1–16
Species the MIDI receive channel that switches phrase memories and controls
the RC-10R.
If this is “OFF,” these messages are not received.
RX NOTE CH
OFF, 1–16
Species the MIDI receive channel that plays the RC-10R’s rhythm sounds.
If this is “OFF,” these messages are not received.
TX CONTROL CH
OFF, 1–16, RX
Species the MIDI transmit channel on which controller messages are sent.
If this is “OFF,” these messages are not sent.
If this is “RX,” the same channel as the RX CONTROL CH setting is used.
PC IN/OUT
Species whether a program change is transmitted when you switch phrase memories.
* Nothing happens when a program change 100–128 is received.
* Incoming MIDI bank select messages (control change #0 and #32) are ignored.
OFF
A program change message is not transmitted when you switch phrase memories.
In this case, the phrase memory is not switched even if a program change message
is received from an external device.
ON
A program change message is transmitted when you switch phrase memories. In
this case, the phrase memory is switched if a program change message is received
from an external device. Program numbers 1–99 correspond to phrase memories
01–99.

Boss RC-10R Specifications

General

Sound effects	Looper, Reverberation
Sound effects quantity	-
DC-in jack	Yes
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired
6.35 mm (1⁄4-inch) input	1
Display type	LCD
Power source type	DC

Weight and Dimensions

Depth	138 mm
Width	101 mm
Height	63 mm
Weight	620 g