12
About Rhythm
Sounding a Rhythm
1. Press the [RHYTHM ON/OFF] button to switch the
rhythm sound between playing and stopped.
• Use the [OUTPUT RHYTHM] knob to adjust the volume of the
rhythm.
• The [TAP TEMPO] button will blink in time with the rhythm (red
on the rst beat, green on subsequent beats).
• When you save a phrase (p. 8), the rhythm type and time
signature selected at that time will also be saved.
Setting the Tempo
When recording, you can set the tempo before you start recording.
When playing back a saved phrase, you can change the playback
tempo without changing the pitch of the phrase.
1. Use the [ ] / [ ] buttons to select the phrase
memory whose tempo you want to set.
2. Press the [TAP TEMPO] button several times at the
desired tempo.
The tempo will be set to the interval at which you press the
button.
• If the RC-3 is stopped, the rhythm ([RHYTHM ON/OFF] button)
will turn on after you set the tempo.
* You can only change the tempo of phrases that have been
saved in phrase memory. If you want to change the tempo of
a phrase immediately after recording or overdubbing, you
must rst save it to phrase memory (p. 8).
* There are limitations on the proportion of the possible tempo
change.
* You can’t specify a tempo that would cause the phrase to
loop in a shorter time than the minimum recording time
(approximately 1.5 seconds).
The tempo setting is stored when you save the phrase (p. 8).
Setting the Rhythm Type
1. Hold down the [RHYTHM
ON/OFF] button for at
least two seconds.
The display will indicate
“r0” – “r9”; the RC-3 is now in
rhythm type selection mode.
2. Use the [ ] / [ ] buttons
to select the desired
rhythm type (r0–r9).
3. Press the [RHYTHM ON/
OFF] button to return to
normal operation.
Rhythm Type List
r0
Hi-Hat
r1
Kick & Hi-Hat
r2
Rock 1
r3
Rock 2
r4
Pop
r5
Funk
r6
Shue
r7
R & B
r8
Latin
r9
Percussion
To Next Page
Loading...
Need help?
Power
Recording and Playback
Weight and Dimensions
