EasyManuals Logo

Boss RC-3 User Manual

Boss RC-3
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Connecting to Your Computer via USB
15
English Deutsch Français Italiano Español Português Nederlands
NOTE
* Do not delete the folders inside the BOSS_RC-3 drive unless
you are performing a recovery operation.
* You can use the following characters in  le names.
A–Z (uppercase letters), 0–9 (numerals), _ (underscore)
* Do not place more than one WAV  le in any folder. If a folder
already contains a WAV  le, do not overwrite it. Write your
WAV  les into empty folders.
4. When you’ve  nished copying WAV  les, disconnect
the USB drive as follows.
Windows 7 users
In the lower right of your screen, click the [ ] icon g [ ]
icon, and then click “Eject RC-3.
Windows Vista/Windows XP users
In the lower right of your screen, click the [ ] icon ([ ] in XP)
and then click “Safely remove USB Mass Storage Device.
Mac OS users
Drag the “BOSS_RC-3” icon to the trash (“Eject” icon).
5. Disconnect the USB cable from your computer.
When you have disconnected the USB cable, the display will
indicate dC and the [RHYTHM ON/OFF] button will blink.
6. Press the [RHYTHM ON/OFF] button to return to
normal operation.
The dC indication will disappear from the display, and the RC-3
will return to normal operation.
15
Español
Português
NOTE
* Never use your computer to format the “BOSS_RC-3”
drive. Doing so will cause the RC-3 to stop operating
correctly. If this occurs, executing the format using
the procedure described in “Formatting the Internal
Memory (p. 19).
* Never perform the following actions until you have
disconnected the USB drive. Doing so might make your
computer freeze, or might result in the loss of all of the
RC-3’s data.
Disconnect the USB cable.
Allow your computer to enter suspend (standby) or
hibernate mode, restart it, or shut it down.
Turn o the RC-3’s power.
* Unfortunately, it may be impossible to restore the
contents of data that was stored in the unit’s memory
once it has been lost. Roland Corporation assumes no
liability concerning such loss of data.

Other manuals for Boss RC-3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Boss RC-3 and is the answer not in the manual?

Boss RC-3 Specifications

Power IconPower
nominal output level-20 dBu
output impedance1 k ohm
DC voltage9 V
Recording and Playback IconRecording and Playback
maximum recording timeApprox. 3 hours
maximum number of stored phrases99 phrases
data formatWAV (44.1 kHz, 16-bit linear, stereo)
Weight and Dimensions IconWeight and Dimensions
weight450 g
width73 mm
depth129 mm
height59 mm

Related product manuals