To Next PageTo Next Page
Need help?Do you have a question about the Bostitch BT35B and is the answer not in the manual?
General| Type | Brad Nailer |
|---|---|
| Power Source | Pneumatic |
| Fastener Type | Brad Nails |
| Magazine Capacity | 100 nails |
| Operating Pressure | 70-120 PSI |
| Fastener Gauge | 18-gauge |
Mandatory eye protection conforming to ANSI Z87.1 for operator and others against flying particles.
Prohibits use of oxygen, combustible gases, or bottled gases; warns against exceeding 200 P.S.I.G.
Never place body parts in discharge area, point at anyone, or pull trigger while loading.
Handle with care, avoid horseplay, only pull trigger when nose is at work.
Do not hold trigger pulled on contact arm tools except during fastening.
Keep hands and body away from discharge area to prevent injury from recoil bounce.
Drives fastener when contact trip meets work and trigger is pulled; includes single/rapid placement.
Requires contact trip to be on work before trigger pull for precise fastener placement.
Additional safety rules including proper use, handling, and maintenance of the tool.
Identifies causes and corrections for air leaks in trigger valve housing, stem, and frame/nose.
Troubleshooting for tools that fail to cycle, including lubrication and worn parts.
Addresses causes of reduced power or slow operation, such as lubrication and air restrictions.
Solutions for tools that intermittently skip fasteners or have feed issues.
