To Next PageTo Next Page
Need help?Do you have a question about the Bostitch BCN650 and is the answer not in the manual?
General| Operating Pressure | 70-120 PSI |
|---|---|
| Magazine Capacity | 100 nails |
| Power Source | Battery |
| Battery Voltage | 20V |
| Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| No-Mar Tip | Yes |
| Type | Cordless |
| Nail Length | 1-1/4" - 2-1/2" |
| Magazine Angle | 20 degrees |
| Firing Mode | Contact or sequential |
Essential safety practices for operating the nailer to prevent accidental firing and injury.
Further safety measures for nailer operation, including tool handling and maintenance.
Safety precautions for adjusting fastener depth, including removing the battery pack.
Mandatory safety gear including eye, hearing, and respiratory protection for safe tool operation.
Essential safety guidelines for handling, charging, and storing battery packs to prevent hazards.
Essential safety guidelines for using BOSTITCH battery chargers to prevent hazards.
Essential guidance on how to hold the tool correctly for safety and effective operation.
Step-by-step instructions for loading fasteners into the tool's magazine.
Troubleshooting steps for when the motor does not operate when the trigger is pressed.
Troubleshooting steps for when the motor does not operate with the contact trip depressed.
Diagnosing and fixing issues where the tool's motor runs but no fastener is fired.
Solutions for when the drive blade repeatedly gets stuck in the down position.
Diagnosing and resolving issues where fasteners are not driven completely into the material.
Troubleshooting common causes for the tool operating without driving fasteners.
Steps to identify and resolve issues related to jammed nails in the tool.
