To Next PageTo Next Page
Need help?Do you have a question about the Bostitch SMART POINT BTFP12233 and is the answer not in the manual?
General| Type | Brad Nailer |
|---|---|
| Power Source | Pneumatic |
| Magazine Capacity | 100 |
| Operating Pressure | 70-120 PSI |
| Tool-Free Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| No-Mar Tip | Yes |
| Fastener Type | Brad |
| Fastener Length | 5/8 to 2-1/8 inches |
| Fastener Size | 18-gauge |
Study manual for safety warnings and instructions. Contact distributor for questions.
Overview of the BOSTITCH BTFP12233 tool and importance of following manual instructions.
Details the 7-year limited warranty for pneumatic nailers in the U.S. and Canada.
Explanation of safety symbols and general guidelines for safe tool operation.
Mandatory safety precautions including eye, hearing, and head protection requirements.
Additional safety rules to observe for proper and safe tool operation.
Diagram and labels identifying the various parts of the BOSTITCH BTFP12233 nailer.
Technical details of the tool, including pressure, fastener type, capacity, and dimensions.
Compatibility chart for BOSTITCH BT13XX series brad nails used with the tool.
Guidelines for connecting the tool to compressed air supply, including warnings.
Safety warnings and initial steps for loading fasteners into the tool's magazine.
General safety warnings for operating the pneumatic tool during use.
Explanation of the two selectable trip modes: Contact and Sequential Operation.
Instructions on how to change the tool's operating mode between contact and sequential.
Guide to adjusting the fastener drive depth using the Dial-A-Depth® control.
Detailed instructions on operating the tool in both Contact and Sequential Trip modes.
General guidance on maintaining the pneumatic tool for optimal performance and longevity.
Instructions for attaching the belt hook accessory to the tool.
Guide on how to use the pencil sharpener integrated into the belt hook.
Step-by-step instructions for clearing jammed fasteners from the tool's nose.
Procedure to verify tool functionality after potential damage or repair.
Details on replacement parts, seal assembly, and air supply requirements for maintenance.
Importance of adequate air volume and pressure for tool performance and maintenance.
A schedule for routine maintenance tasks and their recommended service intervals.
Common problems, their causes, and suggested corrections for the pneumatic tool.
Information on available accessories and rebuild kits for the tool.
Instructions to contact BOSTITCH for assistance instead of returning the product to the store.
