To Next PageTo Next Page
Need help?Do you have a question about the Bostitch BTFP71917 and is the answer not in the manual?
Details required eye protection conforming to ANSI Z87.1 standards.
Discusses need for hearing and head protection in certain environments.
Warns about dust containing chemicals known to cause cancer or birth defects.
Lists safety precautions to avoid injury during tool loading.
Step-by-step instructions for loading nails into the magazine.
Explains the tool's unique trip mechanism normally in 'depressed' or 'up' position.
Explains selectable trigger modes: sequential and contact.
Covers safe handling, trigger use, recoil, deflection, and flammable substances.
Advises performing an operation check if the tool is dropped or damaged.
Emphasizes extra care when evaluating problem tools during maintenance.
Specifies the recommended operating pressure range and maximum.
Explains required air volume (CFM) for operation and compressor sizing.
Lists compatible fastener types, SKUs, crown width, gauge, and length.
Advises installing a free-flowing male plug that releases air pressure when disconnected.
Specifies minimum working pressure rating and fitting requirements for air hoses.
Reiterates using only clean, regulated compressed air, avoiding specific gases.
States requirement for a 0-125 p.s.i. regulator and warns against exceeding 200 p.s.i.
Warns against exceeding recommended operating pressure to avoid tool wear.
Explains the importance of clean air filters for performance and wear.
Emphasizes wearing eye protection when connecting to air, loading, operating, or servicing.
Lists specific actions to avoid during loading to prevent accidental actuation.
Step-by-step instructions for loading nails into the magazine.
Warns to disconnect air supply before making adjustments to prevent accidental actuation.
Lists the two selectable modes: Contact Trip Operation and Sequential Trip Operation.
Explains contact trip operation for rapid fastener placement, noting recoil risks.
Explains sequential trip for accurate placement, avoiding accidental firing.
Warns to disconnect air supply before assembly and remove hook for Contact Trip Mode.
Provides step-by-step instructions for installing the belt hook.
Reinforces wearing eye protection conforming to ANSI Z87.1 standards.
Instructs to read manual warnings and refer to specifications before use.
Explains how to operate the tool in contact trip mode.
Explains how to operate the tool in sequential trip mode.
Clarifies the trip's normal position and its function in different modes.
Advises performing an operation check if the tool is dropped or suspected of damage.
Warns to disconnect air supply before making adjustments or disassembling.
Provides step-by-step instructions for clearing jammed fasteners from the tool.
Advises removing all fasteners before performing the operation check.
Lists specific actions to verify the tool cycles correctly in contact trip mode.
Details the checks for sequential trip operation to ensure correct cycling.
Advises extra care when evaluating problem tools during maintenance activities.
Stresses using only genuine BOSTITCH replacement parts and avoiding modified parts.
Guides on cleaning and lubricating internal parts and O-rings during assembly.
Explains how air volume, pressure, and system restrictions affect tool performance.
Includes draining condensation and cleaning assemblies.
Includes checking fastener tightness.
Covers air filter cleaning and no-mar tip replacement.
Covers replacement of O-rings, bumper, headvalve, piston/driver, and cylinder.
Addresses leaks from trigger valve, frame, and nose components.
Covers failure to cycle, incomplete cycles, and lack of power.
Addresses skipping fasteners, intermittent feed, and jams.
Lists the rebuild kit for BTFP71917.
Lists SB16 Series 16 Gauge Straight Finish Nails.
Lists the trigger valve kit for BTFP71917.
General
