To Next PageTo Next Page
Need help?Do you have a question about the Bostitch BTFP1850K and is the answer not in the manual?
General| Power Source | Pneumatic |
|---|---|
| Operating Pressure | 70-120 PSI |
| Magazine Capacity | 100 |
| Fastener Type | Brad Nails |
| Tool-Free Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| Sequential Trip | Yes |
| Nail Gauge | 18 |
Details the air fitting requirements for the tools, including size.
Specifies the recommended operating pressure range for optimal fastener performance.
Describes the requirements for male plug fittings on the tool for air release.
Details specifications for air hoses, including pressure rating and quick disconnect.
Specifies using clean, regulated compressed air and warns against other sources.
Explains the need for a pressure regulator and its operating range.
Advises not to exceed recommended operating pressure for tool longevity.
Highlights the importance of filters for tool performance and wear.
Step-by-step guide for loading specific Bostitch tool models.
Instructions for loading SB-150SX and BTFP1838K models.
Details the operation of tools with a contact trip mechanism.
Explains the operation of tools with a sequential trip mechanism.
Procedures to verify the correct function of contact trip tools.
Procedures to verify the correct function of sequential trip tools.
Recommendations for using genuine Bostitch replacement parts.
Guidance on lubricating and assembling tool seals.
Discusses the importance of adequate air pressure and volume.
Explains the fastener control feature for drive depth.
Provides steps for adjusting the fastener control.
