To Next PageTo Next Page
Need help?Do you have a question about the Bostitch BT50B and is the answer not in the manual?
General| Power Source | Pneumatic |
|---|---|
| Operating Pressure | 70-120 PSI |
| Magazine Capacity | 100 |
| Fastener Type | Brad Nails |
| Fastener Size | 18 Gauge |
| Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| Air Inlet | 1/4" NPT |
| Fastener Length | 5/8" to 2" |
Mandatory eye protection conforming to ANSI specifications for protection against flying particles.
Recommends hearing and head protection as needed for specific work environments.
Details specifications for BT35B and BT50B fasteners, including wire size and range.
Specifies the required air fitting type and size for the tool's air connection.
Defines the recommended operating pressure range for optimal tool performance.
Details the air volume required for the BT35B and BT50B tools at specific operating rates.
Explains the three types of operation: Contact Trip, Sequential Trip, and Trigger Operated.
Instructions for installing the correct male plug for the tool's air connection.
Specifies requirements for air hoses, including pressure rating and quick disconnect fittings.
Emphasizes using only clean, regulated compressed air and warns against other gas sources.
Details the need for a pressure regulator and its operating range for safe tool operation.
Advises not to exceed maximum operating pressure to prevent increased tool wear.
Explains the importance of air filters for tool performance and wear prevention.
Lists safety precautions to prevent accidental injuries during tool loading operations.
Explains how the trigger-operated model drives a fastener with each trigger pull.
Details how the contact trip mechanism works with the trigger to drive fasteners.
Describes the sequential trip operation, requiring contact and trigger actuation.
Step-by-step check for the trigger-operated tool's cycling mechanism.
Step-by-step checks for the contact trip tool's cycling behavior.
Step-by-step checks for the sequential trip tool's cycling mechanism.
Additional general safety precautions for operating the tool.
Recommends using genuine BOSTITCH replacement parts for optimal performance.
Provides guidance on lubricating and assembling internal parts and O-rings during repair.
Explains the importance of adequate air volume and pressure for tool operation.
Details common causes and corrections for trigger valve housing air leaks.
Lists causes and corrections for air leaks from the tool's frame or nose.
Explains reasons for the tool not cycling and provides corrective actions.
Addresses issues of reduced power or slow cycling and their solutions.
Troubleshoots problems with skipped fasteners or inconsistent feeding.
Provides solutions for common causes of fastener jams within the tool.
1 pint Bostitch Air-Tool Lubricant.
1 pint Bostitch "Winter-Formula" Air-Tool Lubricant.
1 quart Bostitch Air-Tool Lubricant.
O-Ring Repair Kit for tool maintenance.
Replacement bumper designed for cold weather conditions.
Kit to convert the tool to a contact trip operation system.
Replacement assembly for the tool's trigger valve.
