Bostitch BTFP1664K User Manual

OPERATION and MAINTENANCE MANUAL
MANUAL DE OPERACIÓN Y DE MANTENIMIENTO
MANUEL D’INSTRUCTIONS ET D’ENTRETIEN
FINISH TOOLS
HERRAMIENTAS DE ACABADO
OUTILS DE FINITION
107674RH 09/30/16
SB-150SX SB-125BN
SB-1664FN
SB-1842BN
SB-1850BN
SB-2IN1
BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO
UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE
INSTRUCTIONS WITH THE TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS,
CONTACT YOUR BOSTITCH REPRESENTATIVE OR DISTRIBUTOR.
ANTES DE OPERAR ESTA HERRAMIENTA, TODOS LOS OPERADORES DEBERÁN ESTUDIAR ESTE
MANUAL PARA PODER COMPRENDER Y SEGUIR LAS ADVERTENCIAS SOBRE SEGURIDAD Y LAS
INSTRUCCIONES. MANTENGA ESTAS INSTRUCCIONES CON LA HERRAMIENTA PARA FUTURA
REFERENCIA, SI TIENE ALGUNA DUDA, COMUNÍQUESE CON SU REPRESENTANTE DE BOSTITCH
O CON SU DISTRIBUIDOR.
LIRE ATTENTIVEMENT LE PRÉSENT MANUEL AVANT D’UTILISER L’APPAREIL. PRÉTER UNE
ATTENTION TOUTE PARTICULIÈRE AUX CONSIGNES DE SÉCURITÉ ET AUX AVERTISSEMENTS.
GARDER CE MANUEL AVEC L’OUTIL POUR FUTUR RÉFÉRENCE. SI VOUS AVEZ DES QUESTIONS,
CONTACTEZ VOTRE REPRÉSENTANT OU VOTRE CONCESSIONNAIRE BOSTITCH.
BOSTITCH FASTENING SYSTEMS
BTFP1850K
Page Size: 5.5x 8.5"
BTFP1838KBTFP1664K

Bostitch BTFP1664K Specifications

General

Power Source	Pneumatic
Operating Pressure	70-120 PSI
Magazine Capacity	60 nails
Nail Angle	Straight
Length	12.5 inches

Summary

Safety Instructions

Air Supply and Connections

Supply Source

Use only clean regulated compressed air. Never use oxygen, combustible gases, or bottled gases.

Regulator

A pressure regulator of 0-125 p.s.i. is required to control operating pressure for safe operation.

Lubrication

Tool Specifications

Fastener Specifications

Operating Pressure

Recommended operating pressure range for optimal tool performance.

Operation

Contact Trip Operation

Describes how to operate tools using the contact trip mechanism for fastener driving.

Sequential Trip Operation

Explains the procedure for operating tools using the sequential trip mechanism.

Troubleshooting

Depth Adjustment

Fastener Control Adjustment

How to adjust the fastener drive depth using the dedicated control knob on the tool.