To Next PageTo Next Page
Need help?Do you have a question about the Bostitch BT200 and is the answer not in the manual?
General| Tool Type | Brad Nailer |
|---|---|
| Power Source | Pneumatic |
| Fastener Type | Brad Nails |
| Fastener Gauge | 18 Gauge |
| Fastener Size | 5/8-inch to 2-inch |
| Nail Size | 5/8-inch to 2-inch |
| Magazine Capacity | 100 |
Overview of Bostitch pneumatic tools for high-speed fastening.
Details Bostitch's product warranty terms and limitations.
Mandatory use of ANSI-compliant eye protection against flying particles.
Requirements for hearing and head protection in specific work environments.
Information on fastener compatibility, size, and range for each tool model.
Details on air fitting requirements, operating pressure, and air consumption.
How to use contact trip for single fastener or rapid fire operations.
Procedure for sequential trip for precise fastener placement.
Description of trigger-only operation without a contact arm.
Visual identification of operation modes based on trigger and trip lever.
Specifications for air fittings, hoses, and acceptable supply sources.
Importance of pressure regulators and maintaining correct operating pressure.
Guidance on filter selection, installation, and cleaning for optimal performance.
Specific instructions for loading fasteners into SL150, SX150, LHF97125.
Specific instructions for loading fasteners into BT125, BT200.
Essential safety rules to observe during tool operation.
Methods for single and rapid fastener driving with contact trip tools.
Steps for operating the tool in sequential trip mode.
How to operate the trigger-only model.
Procedure to verify contact trip operation safety and functionality.
Procedure to verify sequential trip operation safety and functionality.
Procedure to verify trigger-operated tool functionality.
Information on using genuine parts and seal assembly procedures.
Troubleshooting common problems related to air supply pressure and volume.
