Bostitch BCN650 - Tool Operates But No Fastener Is Driven; Jammed Nail Troubleshooting

ENGLISH
15
SYMPTOM CAUSE FIX
Tool operates, but no fastener
is driven
No nails in magazine Load nails in magazine.
Wrong size or angle nails Use only the recommended nails Refer to Nail Specifications.
Debris in nosepiece Clean nose area and watch closely for small pieces of broken nails stuck
in the track.
Debris in magazine Clean magazine
Worn magazine Replace magazine See authorized service center.
Damaged or worn driver blade Replace driver blade See authorized service center.
Damaged pusher spring Replace spring; see authorized service center.
Jammed nail Wrong size or angle nails Use only the recommended nails Refer to Nail Specifications.
Magazine screws not secured after previous
jam clear/inspection
Make sure to tighten magazine hex bolts with wrench provided.
Damaged or worn driver blade Replace driver blade See authorized service center.
Material and fastener length If the unit continues to stall (forcing the need to rotate the Stall release
lever) choose the appropriate material and fastener length that is not too
rigorous an application.
Debris in nosepiece Clean nose area and watch closely for small pieces of broken nails stuck
in the track.
Worn magazine Replace magazine See authorized service center.
Damaged pusher spring Replace spring; see authorized service center.