To Next PageTo Next Page
Need help?Do you have a question about the Bostitch N59FN and is the answer not in the manual?
General| Type | Framing Nailer |
|---|---|
| Power Source | Pneumatic |
| Operating Pressure | 70-120 PSI |
| Fastener Length | 2 in to 3-1/2 in |
| Length | 12.5 inches |
| Nail Shank Diameter | 0.131 inches |
| Nail Head Size | 0.25" |
Mandatory eye protection conforming to ANSI Z87.1-1989 for all operators.
Requirement for hearing and head protection in specific work environments.
Warnings against using oxygen, combustible gases, or exceeding 200 PSI.
Safety measures to prevent accidental injuries during nail loading.
Emphasis on careful handling, trigger use, and body positioning during operation.
Provides dimensions, weights, nail series, gauge, wire size, and fastener range.
Specifies air fitting, operating pressure, and air consumption for optimal performance.
Operation procedure for contact trip mechanism, including single and rapid placement.
Operation for sequential trip, offering accurate placement and safety.
Operation mode cycled solely by trigger actuation.
Guidelines for proper fittings, hoses, and using clean compressed air.
Requirements for a regulator and recommended operating pressure range.
Explains the role of filters in preventing wear and maintaining performance.
Details recommended oiling frequency and lubricant types for internal parts.
Recommendations for cold weather lubrication and tool storage.
Critical safety warnings to prevent accidental actuation during loading.
Step-by-step instructions for loading nails and engaging the pusher.
Instructions to read manual and identify tool operating system before use.
Explanation of single-action fastener driving by trigger actuation only.
Details methods for driving fasteners with a contact trip tool.
Explanation of sequential trip for controlled fastener driving.
Steps to verify the correct operation of a trigger-operated tool.
Detailed checks for contact trip operation functionality.
Steps to verify the correct operation of a sequential trip tool.
Emphasizes using the tool only for its intended purpose.
Covers warnings on misuse, modifications, clamping triggers, and unattended tools.
Caution regarding handling the pusher spring assembly to avoid injury.
Recommendation to use only genuine Bostitch replacement parts.
Importance of adequate air volume and pressure for tool operation.
Lists causes and corrections for air leaks in trigger valve and frame/nose.
Addresses failure to cycle, lack of power, and slow cycling issues.
Covers skipping fasteners, intermittent feed, and fasteners jamming in the tool.
Step-by-step guide to adjust the fastener depth control using the adjusting nut.
Explanation of the Quick Release Door for easy jam removal.
Mandatory safety warning to disconnect air supply before clearing jams.
Caution against pinching hazards when closing the door.
Lists available lubricants, O-ring kits, and bumper kits for maintenance.
Lists other available parts like trigger valve assembly and Loctite.
Disclaimer regarding corrosion resistance of steel finish nails.
