To Next PageTo Next Page
Need help?Do you have a question about the Bostitch N80SB and is the answer not in the manual?
General overview of the Bostitch N79WW/N80SB pneumatic nailer, its design, and intended use.
Details Bostitch's limited warranty terms, coverage, and exclusions for purchasers in the U.S. and Canada.
Mandates ANSI-compliant eye protection against flying particles during operation and servicing.
Advises on necessary hearing and head protection based on work environment noise and hazards.
Prohibits use of oxygen, combustible gases, and over-pressurized air sources for tool safety.
Guidelines on disconnecting air supply and safe handling to prevent unintended fastener discharge.
Rules for safe tool handling, trigger use, keeping clear of discharge, and fastener driving angles.
Warns against using the tool near flammable substances due to explosion risk and potential injury.
Details model, tool actuation types, dimensions, weight, and fastener compatibility.
Specifies recommended operating pressure and air consumption for optimal tool performance.
Explains the two available operation systems and how to identify them by trigger color.
Requirements for fittings, hoses, supply source, regulator, and filter for pneumatic tools.
Instructions on proper lubrication using specific oils, avoiding detergents for tool longevity.
Recommendations for cold weather lubrication and precautions against frost or ice formation.
Step-by-step instructions for loading fasteners into the tool magazine.
Procedure for adjusting the drive depth of fasteners from flush to countersunk.
Detailed explanation of single fastener placement and rapid fastener operation methods.
Explanation of how to operate the sequential trip model for precise fastener placement.
Tests to verify correct operation of contact trip and sequential trip mechanisms.
Additional warnings and guidelines for safe handling, use, and maintenance of the tool.
General warnings and cautions for working on air tools and specific spring assembly handling.
Recommendations for using genuine parts and procedures for assembling seals with lubricant.
Explanation of how air volume, not just pressure, affects tool performance and potential issues.
Lists common tool problems, their causes, and recommended corrections for repair.
Guidance on worn drivers, length adjustment for redressing, and maximum limits.
Instructions on adjusting the directional exhaust deflector for desired airflow direction.
List of optional accessories and replacement parts available for the tool.
General
