Please save these instructions
Safety Instructions
1.Read all of the instructions and cautions in the manual before
installation.
2.There are no repairable parts for this controller,do not disassemble or
attempt to repair the controller.
3.Keep the controller from the water.
4.Make sure all connections with controller are tight.
5.Please read the product installation steps to ensure all connections
are correct.
Please follow the safety instructions for operation, the damage caused
by not following the safety instructions shall be borne by the individual.
General Safety Information
1.NEVER connect the solar panel array to the controller without a
battery. The battery must be connected first.
2.Ensure input voltage does not exceed 55 Voc to prevent permanent
damage.
3.Ensure that the output current of the solar panel does not exceed the
rated charging current of the controller.
Charge Controller Safety
1 . Do NOT let the positive (+) and negative (-) terminals of the battery
touch each other.
2. Explosive battery gases may be present while charging.
Be certain there is enough ventilation to release the gases.
3. Be careful when working with large lead-acid
batteries. Wear goggles and have fresh water available in case there is
contact with the battery acid.
4. Over-charging and excessive gas precipitation may damage the
battery plates and activate material shedding on them. Too high of an
equalizing charge or too long of one may cause damage. Please
carefully review the specific requirements of the battery used in the
system.
Battery Safety
1
To Next Page
Loading...
Need help?
General
