To Next PageTo Next PageWhat to do if my Bounty Hunter The Outback Metal Detector has no power and no sounds?
If your Bounty Hunter Metal Detector has no power or sound, here's what you should check: 1. **Dead batteries**: Replace the batteries. 2. **Cord not connected securely**: Check the connections to ensure they are properly connected.
Why does my Bounty Hunter The Outback chatter or beep erratically?
If your Bounty Hunter Metal Detector chatters or beeps erratically, here's what to check: * **Using detector indoors**: Use it outdoors only. * **Near power lines**: Move away from power lines. * **Using 2 detectors close**: Keep detectors at least 20 feet apart. * **Highly oxidized object**: Only dig up repeatable signals. * **Electromagnetic interference**: Reduce sensitivity until the signals stop.
Why does my Bounty Hunter Metal Detector have a constant low tone or repeating tones?
If your Bounty Hunter Metal Detector is emitting a constant low tone or constant repeating tones, it could be due to: * **Discharged batteries**: Replace the batteries. * **Wrong type of batteries**: Ensure you are using only 9V alkaline batteries.
General| Brand | Bounty Hunter |
|---|---|
| Model | The Outback |
| Category | Metal Detector |
| Language | English |
Instructions for connecting the searchcoil, stem sections, and control housing.
Instructions for correctly inserting 9-volt alkaline batteries into the detector.
Procedure for turning on the detector and understanding its display indicators.
How to use the MODE touchpad to select discrimination settings.
Methods for accurately locating detected targets and proper coil swinging.
