5 Preparation
34 Operating Manual ARC 250 / 303 900-301_IFU-V2.2_11316-S0-20131023-EN
5. Preparation
Pos: 31 /679-BOW A/HF-Geräte/ ARC 300/350/5 Vorbereitung/HF- Gerät aufstelle n @ 6\mod_ 12988737536 90_6.doc @ 490 04 @ 2
5.1. Setting up the HF device
NOTE
When the HF device is used as intended, electromagnetic fields
are generated. This can affect other devices.
Ensure that no electronic devices are set up in the vicinity of the
HF device.
WARNING
Shock hazard!
Always connect the HF device to a mains power system with a
protective earth lead in order to prevent electric shock.
DANGER
Risk of burns to patients due to excessive leakage current!
Do not place the HF device in the immediate vicinity of the patient,
see section Ambient conditions, page 18.
HF devices may be used only in rooms used for medical purposes that
meet the requirements of DIN VDE 0100-710.
If the HF device was previously stored or transported at temperatures
below +10 °C, it will take approximately three hours to adjust to room
temperature.
1. Observe and comply with the operating conditions, see
chapter Operating conditions, page 33
2. Place the HF device on one of the following platforms:
a table,
an equipment trolley,
a console suspended from a ceiling support or wall-
mounted brackets.
if necessary, position the HF generator on the additional
device ARC PLUS
Except for the additional device ARC PLUS, do not place
any other devices on the HF device
To Next Page
Loading...
