EasyManuals Logo

Bowers & Wilkins 702 S2 User Manual

Bowers & Wilkins 702 S2
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
9
ENGLISH
If the bass seems uneven with frequency this will most probably
be a consequence of the acoustic properties of your listening
room. Even small changes in the position of the speakers
or listening position can have a signicant effect on sonic
performance, especially at low frequencies. Try moving your
listening position or locating your speakers along a different
wall if possible.
If no alter
natives exist, you can adjust your loudspeakers’
low-frequency performance using the supplied foam bungs.
The bungs are a two-piece part, allowing for a degree of
ne-tuning using either the outer, larger-diameter piece in
isolation or the two parts together. Using solely the outer,
larger-diameter foam bung will deliver less bass attenuation
than the complete bung assembly.
Befor
e ne tuning, make sure that all the connections in the
installation are correct and secure.
Moving the speakers further from the walls will generally reduce
the volume of bass. Space behind the speakers will also help
to create an aural impression of depth. Conversely, moving the
speakers closer to the walls will increase the volume of bass.
If you want to reduce the volume of bass without moving the
speakers further from the wall, t the foam plugs or, for less
severe bass reduction, the foam rings in the port tubes (above).
4. Fine Tuning

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bowers & Wilkins 702 S2 and is the answer not in the manual?

Bowers & Wilkins 702 S2 Specifications

General IconGeneral
Frequency Response45Hz - 28kHz ±3dB
Sensitivity90dB spl (2.83Vrms, 1m)
Impedance8Ω (minimum 3.1Ω)
Crossover Frequencies350Hz, 4kHz
FinishGloss Black, Satin White, Rosenut
TypeFloorstanding speaker
DescriptionFloorstanding speaker
Recommended Amplifier Power30W - 200W
Drive Units1x 150mm Continuum cone FST midrange
Harmonic Distortion<1%
Dimensions200mm
Weight29.5kg (65 lb)

Related product manuals