48
1. Unplug the power cord from the machine and wait 5 minutes. Place the
power cord in a secure location.
2. . Using a #2 Phillips screwdriver, remove the 4 indicated screws (by
arrows) from Lower Junction Covers.
3. The Upper Junction Covers are released in two steps~ the inner snaps
followed by the outer snap. From the outside of the machine, gently pinch
both of the inside snaps (indicated with ovals) and roll the Upper Junction
Cover up and outward from the machine.
4. With the inner snaps of the Upper junction Covers released, gently
pinch the outer snap (indicated by oval) to release the Upper Junction
Cover.
!
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
wall outlet and wait 5 minutes before cleaning, maintaining or repairing this machine. Place the power cord in a secure
location.
Lower Junction Covers
Upper Junction
Cover
Upper Junction
Cover
To Next Page
Loading...
