Bowflex BXT6 - Page 68

68
46.Thehydraulicliftissetuptodropgradually.Holdontothewalkingdeckuntilapproximately2/3ofthemovementdown.Makesurethatyouuse
proper lifting technique; bend your knees and keep your back straight. Be aware that the walking deck can possibly drop quickly in the last part of the
movement.
If you used spray lubricant, wait 5 minutes before turning on power to the machine to allow the aerosol to dissipate.
47.AttachthepowercordandturnontheTreadmillbyippingthepowerswitchtoON.
48.Startthebeltattheslowestspeedandstandwellbehindthemachine.Letthebeltoperateforapproximately15seconds.NoticeiftheWalking
Belt needs to be adjusted so it runs centered on the machine.
Be sure not to touch the walking belt or step on the power cord. Keep bystanders, children and pets away from the machine you are
servicing at all times.
49.IftheWalkingBeltneedstobeadjusted,usea6mmhexwrenchontheside
the belt should move away from and rotate the Adjustment Bolt a 1/4 turn clock-
wise.
50. Allow the Walking Belt to adjust to the new tension by allowing it to run a
couple seconds.
51. Repeat steps 49 and 50 until the Walking Belt is centered.
52. Switch off your machine.
53.Takecaretocleanupanyexcesslubricantfromthedeck.
To decrease the possibility of slipping, be sure the deck area is free from grease or oil. Clean off any excess oil from the machine
surfaces.
54. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner’s
Manual.
Adjustment Bolt