Bowflex Conquest - Page 10

10
How To Use Your Bowflex Conquest
™
Home Gym
Using Your Leg Press Belt
Leg Press Belt: The Leg Press Belt is used for the Leg Press exercise.
• With the Bowflex
®
seat adjusted to the “free sliding” position (spring
lock seat pin unlocked), the hand grips removed, and the desired amount
of resistance hooked up, sit on the seat and position the leg press belt
around your hips.
• Slide forward to the pulleys and place your feet through the right and left
openings under the rod cables.
• Attach the rod cables to the D-rings on the Leg Press Belt so that the
belt is taut.
• Place hands on vertical main frame and push yourself back while placing
feet, one at a time, onto the pulley frame.
• Grasp belt near where it’s attached to the cables and begin to press back.
Attaching The Squat Cables
• Extend the Squat Bar Cables up to
the Chest Bar Pulleys and attach
the ends using the Snap Hooks.
• Use Snap Hooks to attach the Squat Bar
Straps to the opposite end of the
Cables.
• Use Snap Hooks to attach the Squat Bar
Straps to the Squat Bar.
Attaching The Cables
Snap Hook
Squat Bar
Snap Hook
Squat Cable
Chest Bar Pulley
Squat Bar Strap