Bowflex HVT - Page 110

110
10. Using a #2 Phillips screwdriver, remove the appropriate Pulley from
the Low-Tension, Floating Pulley.
Note: Be sure to note the routing of the rope before removing the Pulley.
11. With the new Low-Tension, Floating Pulley, route the rope and attach
the Pulley exactly as it was before removal on the old Floating Pulley.
12. Repeat with the remaining Pulley, and route and attach it to the new
Floating Pulley.
Note: Rear Upper Shroud removed for clarity.
Low-Tension,
Floating Pulleys
Low-Tension,
Floating Pulleys
Note: These images show the removal of the Load-Bearing, Floating Pulley The assembly is similar to the Low-
Tension, Floating Pulleys except for hardware.