97
31. Attach the Shifter Assembly to the Static Handlebar and Attach the Grip
NOTICE: Do not crimp the Cable. Hardware is pre-installed and not on Hardware Card (*). Be sure the settings on the Shifter As-
sembly are visible to a User before fully tightening the hardware.
Note: A small application of soapy water can be used to ease the Static Handleber Grip onto the Handlebar.
*
X1
#2
32. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
To Next Page
Loading...
