Need help?Do you have a question about the bq Hephestos 2 and is the answer not in the manual?
Update the firmware to fix bugs and enable 9-point mesh levelling for improved Z-height accuracy.
Configure layer height, extrusion width, and speed for optimal first layer adhesion and print success.
General| Build Volume | 210 x 297 x 220 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Heated Bed | Yes |
| Bed Temperature | up to 100 °C |
| Nozzle Temperature | Up to 260°C |
| Display | LCD |
| Technology | FDM (Fused Deposition Modeling) |
| Supported Materials | PLA, ABS |
To Next Page
