Braeburn 1220 - Set Installer Switches; Installer Switch Settings; Attach Thermostat to Sub-Base; Mounting Procedure

Factory Setting
Switch Default Options Comments
5
Heat Pump Systems (cont.)
NOTES - Heat Pump Systems
[1]*GCBUUFSJFTBSFJOTUBMMFEUIF7PMU"$DPNNPODPOOFDUJPOJTPQUJPOBM
[2]4FMFDUOGPSDPPMBDUJWFPS BGPSIFBUBDUJWF
[3]*OTUBMMBmFMETVQQMJFEKVNQFSCFUXFFOUIFW2 and EUFSNJOBMTJG
 UIFSFJTOPTFQBSBUFFNFSHFODZIFBUSFMBZJOTUBMMFE
Provide disconnect and overload protection as required.
 $0/7)1 $0/7
 '$ '
 )&)( )(
Set Installer Switches
4
 $0/7 4FMFDUGPSDPOWFOUJPOBMTZTUFNT
 )1 4FMFDUGPSIFBUQVNQTZTUFNT
 ' 4FMFDUGPSGBISFOIFJUUFNQFSBUVSFTDBMF
 $ 4FMFDUGPSDFMTJVTUFNQFSBUVSFTDBMF
 )( 4FMFDUGPSHBTIFBU
 )& 4FMFDUGPSFMFDUSJDIFBU
Attach Thermostat to Sub-Base
5
-JOFVQUIFUIFSNPTUBUCPEZXJUIUIFTVCCBTF
$BSFGVMMZQVTIUIFUIFSNPTUBUCPEZBHBJOTUUIFTVCCBTFVOUJMJUTOBQT
 JOUPQMBDF
*OTFSURVJDLSFGFSFODFDBSEJOUPTMPUPOUPQPGUIFSNPTUBU
NOTE: Installer switches are located on the back of the thermostat. The
reset button must be pressed after making any changes to these switches.
UP UP