MODEL
5200
OWNERS MANUAL
Premier Series
7-Day Programmable
2-Heat / 2-Cool & Heat Pump
Digital Thermostat
Compatible with low voltage multi-stage heat
pump systems with up to two stages of heating
and two stages of cooling. Not for use on
single-stage heating or cooling systems.
READ ALL INSTRUCTIONS BEFORE PROCEEDING
© 2004 Braeburn Systems LLC All Rights Reserved. Pub. No. 5200-100-002
Store this
booklet for
future reference
Braeburn Systems LLC, as an Energy Star partner
has determined that this product meets the Energy
Star Guidelines developed by the U.S. Environmental
Protection Agency & the U.S. Department of Energ y
for maximum energy efficiency.
WARRANTY
YEAR
LIMITED
CONTENTS
WARNING!
Quick Reference/I nstallation Guide
Important Safety Information
• Always turn off power to the air conditioning or heating system prior to installing,
removing, cleaning or servicing thermostat.
• Read this manual thoroughly prior to installing, programming or operating this
thermostat.
• This thermostat is designed for use with a 24 Volt AC low voltage multi-stage heat
pump system.
• Do not use this thermostat on single stage systems or other systems with
voltages higher than 30 Volt AC.
• This thermostat requires 24 Volt AC power for normal operation and control of the
heating or cooling system.
• This thermostat also requires two (2) properly installed "AA" alkaline batteries to
retain user settings and programs in the event of loss of AC Power due to power
outage or rolling blackouts.
• Wiring must conform to all building codes and ordinances as required by local
and national code authorities having jurisdiction.
• Do not short (or jumper) across terminals on the gas valve or at the heating or
cooling system control board to test the thermostat installation. This could
damage the thermostat and void the warranty.
• Do not select COOL mode of operation if the outside temperature is below 50˚ F
(10˚ C). This could possibly damage the controlled cooling system and may cause
personal injury.
• This thermostat should only be used as described in this manual. Any other use
is not recommended and will void the warranty.
1
FEATURES
SPECIFICATIONS
INSTALLATION
Replacing Existing Thermostat
Installing Your New Thermostat
TESTING YOUR NEW THERMOSTAT
PROGRAMMING
Default Thermostat Settings
Setting Current Time of Day and Day of Week
Setting Temperature Differential and Residual
Cooling Fan Feature
Setting First Stage Differential
Setting Second Stage Differential
Setting Residual Cooling Fan Feature
Setting Your Energy Saving Programs
T ips Before Starting
Using Quick Program Groups
or Individual Day Programming
Entering Your Program
ADDITIONAL OPERATION FEATURES
Review Set Temperature
Temporary Program Override
P ermanent Hold (Vacation) Mode
Efficient Recovery Mode (ERM
™
)
Compressor Protection
High Temperature Safety Switch
Changing Fahrenheit (˚F) to Celsius (˚C)
Low Battery Detection and Replacement
Replacing the Back-up Batteries
Resetting Thermostat
Multi-Colored LED Indicators
TROUBLESHOOTING
WIRING DIAGRAMS
1
2
3
4
5
6
7
8
5.1
3.1
3.2
5.2
5.3
5.4
6.1
6.2
6.3
6.4
6.5
6.6
6.7
6.8
6.9
6.10
5.3.1
5.3.2
5.3.3
5.4.1
5.4.2
5.4.3
6.8.1
To Next Page
Need help?
General
