Brand Developers Fish Seeker - Page 17

Fish Seeker Owner's Manual Page 16
7 It is normal for a small gap to remain in some secons of the
sealing faces. This is normal. As long as the gap closes in some
areas the seal will funcon properly.
8 If the e rod is not already vercal, ghten unl it becomes
vercal (less than half a turn is all that is needed)
Once this is properly fastened in the front secon, there should
be no movement between the two pieces.
A small gap at top
is not an issue if the
gap is fully closed at
the boom.
Small Gap
No Gap
Assembling your Fish Seeker