Brand Developers Fish Seeker - Troubleshooting Common Issues; Navigation and Starting Problems; Heading and Power-Up Issues; Trace Tangling Solutions

Page 35 Fish Seeker Owner's Manual
Tips and troubleshoong
Troubleshoong
Problem Possible Reason Soluon
Fish Seeker
does not stay on
course
Fish Seeker requires
recalibraon
Fish Seeker requires a new
heading set
Follow recalibraon
procedure
Follow the set heading
procedure
Motors pulse
4 mes when
trying to start
Baery is low
Heading has not been set
Calibraon has not been
done
Charge the baery
Follow the set heading
procedure
Follow the recalibraon
procedure
Motors pulse
4 mes when
trying to set
heading
Calibraon has not been
done
Follow the recalibraon
procedure
Motors pulse
4 mes when
baery is rst
plugged in
Compass cable is not
plugged in
Compass cable connecon
is poor
Unplug the baery, plug
in the compass
Cable then plug in the
baery again.
Unplug and plug the
compass cable back in
Trace becomes
tangled during
shing
Main line has run out of
length
Bait pod not loaded
correctly
Ensure some mainline is
available during the whole
run otherwise tangles can
occur