!
Observe the following safety considerations when operating the Analog
Sonifier
®1
.
1. Make sure that the equipment is properly grounded. DO NOT oper-
ate if it is not.
2. Make sure the unit is equipped with a three-conductor cord and
three-prong grounding-type plug and must be plugged into a three-
prong ground-type wall receptacle. DO NOT under any circum-
stances remove the power cord ground prong.
3. DO NOT operate equipment with the cover removed. High voltage
is present within the equipment when connected.
4. DO NOT allow the horn or micro tip to contact lab stands, beakers,
etc. or horn/micro tip failure may result.
5. DO NOT turn on the ultrasonics without the converter and tool
attached.
6. DO NOT touch the horn or tip when ultrasonics are active. When
handling, removing, or attaching a tool or tip, be sure that the ON/
OFF switch is set to OFF. Touching the tool while the unit is on can
result in serious personal injury.
!
If the Sonifier is used in a manner not specified by Branson, the protec-
tion provided by the equipment may be impaired.
1. Sonifier is a registered trademark of Branson Ultrasonic Corporation
To Next Page
Loading...
