2
System Capabilities
Recommended Maximum Iron in Raw Water: MB-100 - 5 PPM (mg/L)
Recommended Maximum Iron in Raw Water: MB-200 - 5 PPM (mg/L)
Feed Water Temperature Range: 34 - 110
o
F
Feed Water Pressure Range: 30 - 100 PSIG
Service Flow Rate for MB-100: 10 GPM at 12 PSID
Service Flow Rate for MB-200: 12 GPM at 15 PSID
System Capacity for MB-100: 650 Gallons
System Capacity for MB-200: 1,200 Gallons
System Performance (Average Reductions): Iron - 96.75%, and Hydrogen Sulfide - 97.99%
Regeneration Water Usage
Media Regeneration Frequency: See page 5 for additional information.
Model MB-100 88 gallons
Model MB-200 130 gallons
Performance Data Sheet Reduction Claims
Substance Influent Challenge
Concentration
Maximum Permissible Product
Water Concentration
Hydrogen Sulfide 1.0 PPM (mg/L) ± 10% 0.05 PPM (mg/L)
Iron 3 to 5 PPM (mg/L) 0.3 PPM (mg/L)
1. Testing was performed under standard laboratory conditions, actual performance may vary.
2. This system has been tested according to NSF/ANSI 42 for reduction of the substances
listed above. The concentration of the indicated substances in water entering the system
was reduced to a concentration less than or equal to the permissible limit for water leaving
the system, as specified in NSF/ANSI 42.
3. Systems conforms to NSF/ANSI 42 for the specific performance claims as verified and sub-
stantiated by test data.
Note: This system is not intended to be used for treating water that is microbiologically
unsafe or of unknown quality without disinfection before or after the system.
For additional information on performance test data contact:
WCC (Water Control Corporation)
7150 143
rd
Ave NW ● Ramsey, MN 55303
Phone: 1-866-405-1268 ● Fax: 763-427-5665
www.watercontrolinc.com
To Next Page
Loading...