12 13
4. Press down the green opening lever completely until
it locks in place and yellow triangle light is ashing.
Remove IV line from right to left.
5. Insert new IV line following steps in “Open Door and
Load IV Line” section above.
END INFUSION AND POWER OFF
1. Press to stop the infusion.
2. Follow steps 2 through 4 above to remove IV line.
3. Close the pump door.
4. Press for 3 seconds to power o
the pump.
NOTE: Pump cannot be powered o with IV line inserted.
STANDBY MODE
1. Press to stop the infusion. Leave the IV line
inserted in the pump.
2. Press and hold for 3 seconds.
3. Exit Standby by pressing .
INFUSION TOTALS
1. From the Home screen scroll to “Infused Totals” using
and selecting with .
2. PRIMary, SECondary and Totals of both are displayed.
3. Scroll to desired value using and select with .
4. Respond to “Reset values to zero?” prompt by press-
ing for “Yes” and
for “No”.
NOTE: Infusion totals are automatically cleared when
“No” is selected to “Continue last infusion?” on power up.
To Next Page
Loading...
