Braun IryPump S - User Manual

IryPump
®
S
Rectal Irrigation - Step by Step Guide
Turn on the IryPump
®
S
to check if the battery is
properly charged.
Ring is red = IryPump
®
S
needs charging. Ring is
green = ok to begin
irrigation.
Remove the water
container from the pump
module by pressing the
side release button.
Extend the water
container. Pull the inner
section up until it
audibly clicks into position.
Fill the water container
with the advised amount
of water. Temperature
between 36°C and 38°C.
Attach the lled water
container back onto the
pump module.
Use the quick connector
to fasten the tubing
system onto the pump.
Connect the other end of
the tubing system to the
cone.
Expel all air from the
tube by turning the
control wheel to level 3.
Ensure that you are in
a comfortable position.
Lubricate the cone and
carefully insert it into the
anus.
Hold the cone in place by
applying a slight pressure
throughout the irrigation
procedure.
tip!
Use a water based
lubricant to lubricate
the cone.

Braun IryPump S Specifications

General

Model	IryPump S
Type	Infusion Pump
Manufacturer	Braun
Infusion Modes	Continuous, Intermittent, PCA
Flow Rate Range	0.1 ml/h to 1200 ml/h
Volume Range	0.1 ml to 9999 ml
Power Supply	100 - 240 V AC, 50/60 Hz
Battery Life	Up to 8 hours
Display	LCD
Alarms	Occlusion

Summary

IryPump S Rectal Irrigation Guide

Check Battery Status

Check battery status by turning on the IryPump S.

Indicator Light Status

Battery indicator status: red means charging, green means ready.

Water Container Preparation

Extend container, fill with advised water at 36-38°C.

Tubing System Connection

Connect tubing to pump and cone using quick connector.

Air Expulsion and Insertion

Purge air, position comfortably, lubricate, and insert cone.

Cone Placement during Procedure

Maintain slight pressure on the cone during irrigation.

Irrigation Procedure Steps

Initiate Irrigation

Turn on the IryPump S with the cone held in place.

Pump Level Adjustment

Set the pump level as advised by your nurse; water volume decrease indicates flow.

Pre-Rinse Recommendation

A pre-rinse with 150-250 ml of water can enhance effectiveness.

Post-Irrigation Waiting Period

Turn off the IryPump S after water flow, wait 2-3 minutes before cone removal.

Defecation Process

The defecation process will begin; timing varies per individual.

System Cleaning and Charging

Clean the IryPump S with warm soapy water, dry, and recharge if needed.

IryPump S Product Information

Complete Starter Set Contents

Details the components included in the IryPump S starter set.

Available Accessories

Lists optional accessories for the IryPump S system.